Langshao’s Pillar Set 1
1-2 高速2车道x2，下方可放置一条8车道并且不会影响网格
3-4 高速3/4车道x2
5-6 高速3/4车道x2，中间可架设地铁（12m）
7-8 高速3/4车道x2【桥墩要比3-4更直】
桥墩原型：上海中环（北环）
必须mod：network skins
求点赞求点赞求点赞！
使用方法：
1.先用小一些的桥墩拉出并排道路【请尽量对齐桥上的节点，若要造无缝桥请先用moveit把一小节桥对齐后再延长】
2.把network skin里的桥墩设置好，用道路里的升级工具调整两次方向即可
注意：1.匝道处不适合用3-4号共用桥墩（若高于12m5-6号也不适合，若要用的话用对向桥墩做成弯拱门式桥墩）
2.1-2号桥墩不太适合在弯道处使用（反着用做成拱门除外）
3.共用桥墩在比较小的弯道处使用时没什么大问题的
1 Side Highway 2 cell
2 Side Highway 2 cell Flipped
3 Side Highway 3/4 cell
4 Side Highway 3/4 cell Flipped
5 Side Highway 3/4 cell with elevated metro（metro-12m）
6 Side Highway 3/4 cell with elevated metro（metro-12m） Flipped
7 Side Highway 3/4 cell（more straight than 3-4）
8 Side Highway 3/4 cell Flipped（more straight than 3-4）
Hey buddy,are you complains about the car hit the pillar?are you complains other’s side pillar can’t add lights on it?now there’re some new pillars for you,it has lights on the pillar and it doesn’t effect car on the road.
*Network skins is required*
*Move it is recommended*
PLEASE RATE IT IF YOU LIKE~~
How to use:
1. Put your roads on the map with a small pillar（default/Y-Pillar/.etc）
2. Use MOVE IT to piece the roads and nodes together.（a little seam has no influence）
3. Use upgrade tool to apply the pillar.
Warning:
1.Some intersection and ramps are not suitable for 3/4 pillars（you can use flipped pillars to make a "archway"）,if the roads are above 12m, 5/6 are not suitable too.
2.Please check it out your folder,if it doesn’t have"Pillar.xml",please add it（or you can’t see the pillar at network skin
请注意检查订阅后是否会有Pillar.xml ，若没有请自行添加（新建txt空白文档直接改名）【否则network skin无法读取
Revisions:
Old revisions of this mod are available below. Click the link to download.
