SBB Platform Network

A series of station platforms, inspired by those found in stations across Switzerland operated by the Swiss Federal Railway SBB CFF FFS. These networks require the Adaptive Networks mod, to allow you to use all the different variations, and enable the integrated props.

The model dimensions are based on Zarrix’s Italian Station Platforms and should work seamlessly alongside them.

The pack contains two networks, which when combined with Adaptive Networks allows for 60 different variations:

• SBB Platform Network – A two-sided, 8m wide platform
• SBB Platform Network (Half) – A single-sided, 4m wide platform

With the Adaptive Networks mod, you get access to the following options to allow you to tweak the network’s look to your preference.

Surface Texture

• Old Asphalt – Based on Zürich Hauptbahnhof Main Terminal
• New Asphalt – Based on Bahnhof Aarau
• Concrete Tiles – Based on Bahnhof Chur
• Granite Tiles – Based on Zürich Flughafen Bahnhof
• Marble Tiles – Based on Zürich Hauptbahnhof S-Bahn Terminal

Edge Style

• Clean – Based on Zürich Hauptbahnhof S-Bahn Terminal
• Weathered – Based on Zürich Hauptbahnhof Main Terminal
• Rough Stone – Based on Bahnhof Sargans

Platform Height

• Standard Entry
• Low Entry

Props
All of the prop dependencies listed to the right are optional. The only required dependency is Adaptive Networks. Once subscribed, the props can be enabled individually with Adaptive Networks.

• Platform Displays
• Trash Cans
• Timetable
• Benches
• Interactive Displays
• Lights
• Clock
• Ashtray

For the half/single-sided network, there are two lists of props. The second list is to be used when the network is inverted.

End Caps
Currently only available on full-width network.
If either end of the segment is an end node, checking this box will add an end cap prop to the end of the segment.

Underpass
Currently only available on full-width network.
If either end of the segment is a bend or custom node, checking this box will add an underpass prop to the end of the segment.

To enable underpasses, choose a node on which you want the underpass to appear, and use Node Controller or Node Controller Renewal to set the node type to "Bend", and set an offset of 4m. Then choose a segment either side, and check the "Underpass" box in Adaptive Networks segment flags. The stairs of the underpass will be facing the segment with the flag enabled.