32m 4 Stop Tram Exchange (Single Segment Design)
If you really want to show your appreciation, you could donate to my gofundme page! Every little bit helps this poor uni student! https://goo.gl/GRU8WG
This is a road specifically for placing tram stops on. It’s designed NOT as a full stretch of road but as a single segment. To use, upgrade one road segment and it will blend seamlessly into the game visually and technically. If you decide to use it as a full stretch of road just know that the nodes will not have tracks connecting them. technically it should still all work fine, but this was not the intention of the design.
Elevations:
ground
elevated
Allows you to place 4 stops parallel (two in either direction) with 1 car lane in either direction. Buses can stop on this road but there is no bus bay to pull over in so be wise about whether you place a bus stop or not.
Make suggestions by filling out this form[goo.gl]
Follow These steps if you believe this asset is causing you a problem:
1: Close Cities Skylines (quit to desktop)
2: Use launch parameters to set "–disableMods" > See here for a guide on setting launch parameters
3: Launch the game
4: Start a new game 100% vanilla
5: test thoroughly the asset to see if it presents the same problem (yes you may have to play and build a quick test city to do so)
6: If the problem still persists, please upload the same vanilla save file you tested in making sure you have not used any other custom assets (so they don’t disappear when I load it) and paste a link to the savegame in the discussion thread "Troubleshooting Savegames"
